DDA Sandman Panelvan - HJ One Tonner Chassis + Options
3D Resin Printed Upgrade Kit FB
Add one of these upgrade kits to your DDA Sandman kit and add soooo much more detail and eye candy to your model.
Pictures are of the Designers design, if there is a painted version shown it is for illustration Purposes Only.
CUSTOM 1 TONNER TRAY DESIGNS CAN BE PROVIDED ON REQUEST FOR A SMALL SETUP FEE OF $20. Please fill in a contact form and provide photos of what you're after.
Kit options are (You choose chassis type adjacent):
- 1 Tonner
- Van/Ute TUBBED
- 1 Tonner Tubbed
- Van/Ute Factory
- 1 Tonner Tubbed with Custom Tray
Each option comes with:
- Chassis
- Van ceiling (excluding 1-tonner options)
- Cab ceiling
- Radiator support
- Drum brakes for Fulbore style wheels (factory options only)
- Drum brakes for non FB wheels (factory options only)
- Rear disk brakes (tubbed options only)
- Front brake disks
- Stub axles (reversable to achieve lower stance)
- Stub axle metal insert
- Front sub frame
- Fuel tank
- Gearbox support
- Brake master cylinder
- Heater
- Rear axle and suspension
- Rear axle metal insert
- Tray (separate for 1-tonner options)
- Tail lights (1-tonner options only)
Some "kit bashing" is required to fit these kits to the DDA kits, so please be prepared to cut up your DDA kit before purchasing.
Click here to see required mods.
Resin is not for beginners. As with all resin, parts may need some work like sanding smooth, cleaning flash, evening out surfaces, filling pinholes, reshaping, and/or fabricating parts. Temperature changes during shipping can cause some parts to slightly warp. This can be rectified by warming the part in hot water until it's pliable, then reshaping it while running under cold water. Resin colour may vary from pictures.
The Upgrade kit requires sanding, and clean up. Glues and paint NOT INCLUDED.
All supports will be removed, Some miniatures will require assembly the best glue to use is a good super glue-like Zap-a-gap. Miniatures should be washed in warm soapy water to remove any residual alcohol from the wash after printing and left in the sun to dry.
You will also have to prepare your miniature for painting, there may be some traces of the supports from the printing process, I will have removed them before shipping these can easily be removed with a nail file or sand paper. You may have to work with your model to get it together 100% these kits are 3D printed.
PLEASE NOTE: NORMAL MODEL GLUE DOES NOT WORK WITH 3D PRINTED RESIN.
